Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Lawrence, KS

Clopay Torsion Spring Replacement in Lawrence, KS

Torsion springs replaced and wound correctly, with high-cycle upgrades available. Typical cost $200-$450.

When your door needs Clopay torsion spring replacement, you want it done safely and right the first time. Typical jobs in Lawrence, KS cost $200-$450, and you approve the price first. Torsion springs replaced and wound correctly, with high-cycle upgrades available. We work on Clopay garage doors of every age, from older models to current lines, and carry or can source compatible parts. Clopay is one of the largest residential garage door makers in North America, with lines such as Classic, Modern Steel, Coachman and Canyon Ridge. The model is usually printed on a label on the door's end stile, which helps us match replacement panels.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

Signs you need Clopay torsion spring replacement

  • A gap in the spring mounted on the bar above the door
  • The door slams shut or won't stay open
  • Only one side of the door lifts and the door goes crooked
  • The door is suddenly too heavy to lift by hand

What usually causes it

  • Normal fatigue at the end of the spring's rated cycles
  • Rust or lack of lubrication
  • An undersized spring working too hard
  • A door that's been made heavier with insulation or new panels

What you can check yourself

  • Count the springs above the door. Two-spring doors should have both replaced together.
  • Look for rust or dry, squeaky coils, which are signs the spring is wearing out.
  • Note how often the door is used each day so the right cycle rating can be chosen.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Clamp the door and unwind the old springs with proper winding bars
  2. Measure wire size, inside diameter and length, and weigh the door
  3. Install correctly rated springs, upgrading to high-cycle if you use the door a lot
  4. Wind to the right number of turns and set the door's balance
  5. Lubricate, adjust the cables and test the full travel

Wayne Dalton TorqueMaster doors keep the springs inside the torsion tube and need TorqueMaster-specific parts, which we can source.

Clopay Torsion Spring Replacement cost in Lawrence, KS

$200-$450Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Clopay services

Local Clopay torsion spring replacement for Lawrence, KS

The swing from hot, humid summers to freezing winters in Kansas is hard on spring steel. Rust shortens spring life, and the first cold snap is when a worn spring tends to break.

Technicians serve all of Lawrence (ZIP codes 66044, 66045, 66046, 66047 and 66049), plus Eudora (7.6 mi), Tonganoxie (12.4 mi), Baldwin City (13.8 mi) and De Soto (14.3 mi). Call (833) 435-8883 to book a visit in Lawrence.

Clopay Torsion Spring Replacement: frequently asked questions

How much does Clopay torsion spring replacement cost in Lawrence, KS?

Clopay Torsion Spring Replacement typically costs $200-$450 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Clopay torsion spring replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Clopay torsion spring replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Clopay warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Kansas or Lawrence requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Lawrence, KS

Genie Garage Door Sensor Repair

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $100-$250

Chain Drive Opener Repair

Chain-drive openers repaired, re-tensioned or replaced.

Typical $125-$350

Clopay Extension Spring Replacement

Clopay is one of the largest residential garage door makers in North America, with lines such as Classic, Modern Steel, Coachman and Canyon Ridge. The model is usually printed on a label on the door's end stile, which helps us match replacement panels.

Typical $150-$350

Garage Door Panel Replacement

Dented, cracked or rusted sections replaced or repaired to match your door.

Typical $300-$900

Haas Door Garage Door Installation

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $1,200-$4,500

Linear Opener Gear & Sprocket Replacement

Linear openers and remotes are now part of Nice North America. Linear's MegaCode remotes are common on older openers and gate systems.

Typical $125-$275

CHI Overhead Doors Garage Door Panel Replacement

CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Typical $300-$900

Chamberlain Garage Door Sensor Repair

Chamberlain is the retail line of The Chamberlain Group, sold at home centers. It uses the same Security+ 2.0 remote technology and myQ app as LiftMaster, so many accessories work with both brands.

Typical $100-$250

Amarr Off-Track Garage Door Repair

Amarr, an ASSA ABLOY Group brand, makes residential lines such as Classica, Heritage, Lucern and Oak Summit, as well as commercial doors.

Typical $175-$450

Genie Garage Door Opener Installation

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $350-$800

Trac-Rite Roll-Up Door Repair

Trac-Rite roll-up doors are widely used in self-storage buildings.

Typical $150-$600

Richards-Wilcox Commercial Garage Door Repair

Repairs for commercial sectional, overhead and service doors.

Typical $250-$1,000

Garage door stuck, noisy or broken?

Talk to a garage door technician in Lawrence, KS now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote